✅ What’s Included:

• BackRevive Device
• USB-A to USB-C Cable

⚙️ How to Use:

Auto Mode

1. Connect the device to a power adapter (5V 2A or higher- standard phone charger) using the included cable. The lights on the massager will flash for 3 seconds when powered on.
2. If the lights do not flash, try using a different charger. Some laptop or low-power chargers may not provide enough output, and the device may not turn on.
3. Place it on a flat surface (bed, floor mat, etc.) with the curved side up.
4. Lay down slowly, aligning your lower back with the curve.
5. Press and hold the Auto button for 3 seconds to power on.
6. The device will automatically cycle through:
   🔸 Vibration Massage
   🔸 Heat Therapy
   🔸 Spinal Traction
   (Press the button again to change modes manually.)
7. Relax for 10–15 minutes. Use 1–2 times daily for best results.

Manual Mode

1. Connect the device to a power adapter (5V 2A or higher- standard phone charger) using the included cable. The lights on the massager will flash for 3 seconds when powered on.
2. If the lights do not flash, try using a different charger. Some laptop or low-power chargers may not provide enough output, and the device may not turn on.
3. Place it on a flat surface (bed, floor mat, etc.) with the curved side up.
4. Lay down slowly, aligning your lower back with the curve.
5. Press and hold the Manual button for 3 seconds to power it on.
6. The device will start in Vibration Massage mode. Press the Mode button once to switch to Spinal Traction and Heat Therapy mode.
7. Relax for 10–15 minutes. Use 1–2 times daily for best results.

🔋 Power Info:

• No battery – must be plugged in during use.
• Use with a standard phone charger (5V 2A or higher)

IMPORTANT NOTE:

Not every phone charger is suitable.
The device requires a wall adapter with 5V / 2A minimum.
Older or lower-power chargers (e.g., 5V / 1A) may cause limited functionality or the device not to work properly.